1957 Monarch Series 61 Toolmakers Lathe. Catalog size 13” with an actual swing of 15.5x54” between centers. Equipped with leadscrew reverse, full taper attachment with clamp, Enco CXA toolpost with 3 holders, Cushman 3 and 4 jaw chucks and some additional tooling. Has spindle speeds from 36-1500 rpm. Spindle bore is 1.3125”. Footprint is 9’x4’ and weight is 5000lbs.
This lathe has just had all the gearboxes flushed and refilled with the appropriate oils. The headstock gears look great and the machine runs smoothly in all speeds and feeds. Dual power feed apron with leadscrew reverse and the rare direct length reading dial.
New Fuji VFD controls the motor and will run on single or 3 phase power. Can be inspected under power and I can load it or arrange freight if needed. Thanks!